Toyota Programming final

Toyota_remote_88af0550-77b4-4667-b4ae-c54ffa974ec0

Remote for Toyota

Programming  Instructions

  • Begin with the key out of the ignition, drivers door is open, all other doors and trunk closed and drivers door is unlocked
  • Perform these steps within 5 seconds: 
    A. Insert the key into the ignition (Do NOT Turn it) and Pull key out
    B. Insert the key into the ignition (Do NOT Turn it) and Pull key out
  • Perform these steps within 40 seconds: 
    A. Close then open the drivers door 
    B. Close then open the drivers door 
    C. Insert the key into the ignition (Do NOT Turn it) and Pull key out
  • Perform these steps within 40 seconds: 
    A. Close then open the drivers door
    B. Close then open the drivers door
    C. Insert the key into ignition and leave it in the ignition
    D. Close the driver’s door
    E. Turn the ignition to ON (Do NOT Start or crank engine) then back to OFF
    F. Remove the key from the ignition
  • Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode. Return to Step 1 if the door locks do not cycle at this point
  • Perform these steps within 40 seconds: 
    A. Press the lock and unlock buttons on the remote simultaneously for 1.5 seconds
    B. Immediately after letting go of the lock and unlock buttons, Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock and then unlock once indicating successful programming. If the door locks cycle twice, repeat steps A and B in step 6 as the remote was not accepted.
    C. Repeat steps A and B in step 6 for each new remote
  • Open drivers door, programming is complete
Transpnder

Transponder Key for Toyota

Programming  Instructions

NOTE: Toyota Transponder Key programming up to 2002
This Procedure can be done only if you have a master key (black key)
  • Insert the black programmed key into the ignition
  • Press and release accelerator pedal 5 times within 15 seconds of inserting key into ignition
  • Press and release brake pedal 6 times within 20 seconds of step 2
  • Remove black key from ignition switch
  • Insert unprogrammed key into ignition within 10 seconds of step 4
  • Press and release accelerator pedal once within 10 seconds of step 5
  • Once these steps are performed properly you will see the immobilizer warning lamp begin to flash and after one minute the lamp will stop flashing. Once the immobilizer warning lamp stops flashing you will have ten seconds to insert an additional key to be programmed