Nissan_Remote

Remote for Nissan

Programming  Instructions

  • Get in the driver seat and close all the doors. Lock all the doors using the driver’s side power lock/unlock switch
  • Insert the key into the ignition and remove it from ignition 6 times or more within 10 seconds. Make sure you remove it from the ignition cylinder fully each time 
    (If you remove it too fast, the system will not enter the programming mode. The hazard lamps will begin to flash if you followed the procedure correctly)
  • Once the system enters the programming mode, insert the key into the ignition cylinder once again and turn to the ON position without starting the car
  • Within 5 seconds, push any button only once on the remote transmitter. Your hazard lamps should flash. If you push the button more than once, the procedure will not work
  • If you are programming more than one remote, including the old ones, unlock then lock all the doors again using the driver’s side power lock/unlock switch and within 5 seconds, push any button on the next remote. Hazard lamps will flash
  • Repeat this step for each remote. Turn the key to the OFF position and remove the key from the ignition, unlock the doors using the driver’s side power lock/unlock and open the driver side door